EPA May Revoke New Source Review Rule

April 1, 2010

The U.S. Environmental Protection Agency is proposing to revoke a January 2009 rule that changed the way existing industrial facilities combine upcoming construction projects to determine if Clean Air Act

The U.S. Environmental Protection Agency is proposing to revoke a January 2009 rule that changed the way existing industrial facilities combine upcoming construction projects to determine if Clean Air Act permits are needed.

The 

EPA is concerned that the changes made last year to its "aggregation policy" would make the agency’s New Source Review permitting program less effective, allowing facilities to increase emissions that may impact air quality without a thorough review. 



The new proposal responds to a petition to reconsider the 2009 rule. The 2009 rule directed facilities and permitting authorities to combine emissions from construction projects only when the changes are "substantially related," such as having more in common than the timing of construction.

The 

EPA is proposing to go back to its original policy, which required combining projects based on a broader range of factors. This would ensure that potential emissions increases that could harm air quality do not avoid review and the installation of state-of-the-art pollution controls. 



New Source Review is a pre-construction permitting program to ensure air quality is maintained when factories, industrial boilers and power plants are built or modified. The program ensures that state-of-the art emission control technology is installed at new plants or existing plants that are undergoing a major modification.


The EPA also is proposing to extend the effective date of the 2009 aggregation rule for an additional six months, to give the agency time to complete the reconsideration. 
EPA will take comment on the proposal rule for 30 days after it is published in the Federal Register. 


For more information on the EPA”s New Source Review proposal, visit www.epa.gov/nsr/actions.html.

Sponsored Recommendations

Learn About: Micro Motion™ 4700 Config I/O Coriolis Transmitter

An Advanced Transmitter that Expands Connectivity

Micro Motion™ G-Series Compact, Drainable Coriolis Flow and Density Meters

Micro Motion G-Series Coriolis flow and density meters are ideally suited for Process Monitoring and Optimization applications, offering easy selection with pre-selected models...

Learn about: Micro Motion G-Series Coriolis Flow and Density Meters

The Micro Motion G-Series is designed to help you access the benefits of Coriolis technology even when available space is limited.

Micro Motion 4700 Coriolis Configurable Inputs and Outputs Transmitter

The Micro Motion 4700 Coriolis Transmitter offers a compact C1D1 (Zone 1) housing. Bluetooth and Smart Meter Verification are available.